|
Eke to suite Rational Hives
|
|
|---|
An EKE can be as simple as four planks of wood
50 mm - 100 mm wide nailed together to form a rim the same size as
the hive box.
This can be used over a crown board to house a contact
feeder or a piece of comb that needs "emptying" of stores or brood.
There are other uses as well... If you have only shallow
boxes available and you need to use some deep frames then your eke
can be placed under the shallow box and the deep frames will hang
in the combination of the two boxes as if they were one.
I take this concept a little further... Our British
National brood boxes are 225 mm tall and our supers are 150 mm. I make
my ekes exactly 75 mm and make them to accept frame lugs in the same
manner as the full size boxes. I fit a few with frame runners, but I
use mainly use
castellated spacers in these ekes,
a few with 9's, some with 10's, some 11's and yet others with 12's and
13's spacing.
Two of these ekes clipped together (using
"Z" springs) make 150 mm and
will take super frames.
As my eke's have a selection of spacings available, the
spacing of these frames depends on which eke is placed on top of the
other.
A 150 mm super plus an eke makes 225 mm and will take brood
frames or three ekes can be clipped together and perform the same job.
There is also another size of British Standard frame known
as a 14" x 12" and a standard 225 mm broodbox plus a 75 mm eke will
take these with a slight encroachment into the space within the rim of
the floorboard.
The word "EKE" originates from "to eke out" or stretch your
resources. When bees were kept in straw skeps a "cap" or smaller skep
was often placed on the top for honey production (much like supers
today) if the cap became nearly full the the beekeeper would add a
ring of straw (about 75 mm deep) between the skep and the cap. It is
this ring, that was built like a skep, that was known as an "eke".
There is a complication to this in that if the ring was placed
underneath the skep, then it was known as a "nadir".
Ekes are simple to make and prove very useful to have
around in an apiary. There have been many occasions when I have been
able to get out of... The sort of situation that has a habit of
occuring in beekeeping, just by using one or two.
Cutting of parts (all dimensions are in mm). (When drawings
of parts are available, the table rows will become live links.) The
Grain should run along the longest dimension of any part.
| Qty |
Length | Width |
Thickness | Material | Useage |
|---|
| 2 | 460 |
75 | 18 | Pine | Sides |
|---|
| 2 | 460 | 44 |
25 | Pine | Front and back top rails (rebated) |
|---|
| 2 | 460 |
25 | 22 | Pine | Bottom rails (splayed) |
|---|
| 2 | 424 |
51 | 18 | Pine | Front and back |
|---|
The rebate in the top rail should be 12 mm x 24 mm leaving
13 mm for the section that covers the ends of any topbars.
This cross sectional view
may help assembly.
There is bottom bee space version on the
"National Eke" page.
Scale = 1 pixel per 2mm
Written... 06 February 2002
